10/6/2023 0 Comments For ipod instal Fishing Hook![]() ![]() Mark the plug with a line so you know how deep it must be for it to fit when the iPod is in place.Ĥ) Mix some two part epoxy and glue the plug in place, making sure it sticks out far enough so the iPod can slip on and off.ĥ) Let the expoy harden fully and you are done with the installation of the plug. ![]() This will allow the iPod to slip on and off the plug so the tabs will not have to be pressed.ģ) Check the fit of the iPod and the iPod plug in the dremeled hole. BE SURE TO dremel the slot in the REAR of the cupholder!Ģ) Remove the locking tabs from the iPod plug by filing them flush. Installation of iPod plug in square cupholderġ) Carefully measure and dremel an angled slot in the cupholder for the iPod plug as shown below. It should be fused and the power line should be filtered with an NS-2 filter. This plugs into the A/V port on the back of the Nav radio. HOW TO TURN THE SQUARE CUPHOLDER INTO AN IPOD BASE HOW TO TURN THE SQUARE CUPHOLDER INTO AN IPOD BASEĬlick here to for details on how to purchase any of these items.Ĥ pieces, radio removal tools, Click here to for details on how to purchase any of these items.Ī) Blitzsafe VW/M-LINK V.5 adapter that plugs into the CD changer plug on the back of the standard radio (or the nav radio too) to offer an iPod connector on the other end.ī) Modified Belkin mini-amp cable. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |